Good reasons for... Hirscheider

Fully automatic Enduro V 500 and V 800
end processing systems

We make the processing of large series or heavy, long workpieces easier for you

Our machines and systems from the V 500 and V 800 series are characterised by a modular structure. They are based on a vertical bed on which the processing units and clamping fixtures hang inside
the workspace. Therefore, machining chips fall unhindered onto the underlying chip conveyor.

Your advantages:

+  Optional choice between manual and automated loading
    for large series or heavy / long workpieces by robots / portal / timed conveyors as well  as connections to upstream /
    downstream conveyor / buffer sections.

+  Chips fall unhindered and freely
    onto the underlying chip conveyor. The guide and linear rails are always kept free of chips.

+  Time savings
    Processing operations, such as milling, drilling, centring and thread cutting, are carried out on both sides,
    in one work cycle and without manual intervention. As standard, up to 3 tool spindles are implemented per side. 
    However, special requests are possible at any time.



Diameter: 10 – 400 mm
Length: 80 – 12.000


Enduro V 500 and V 800

For processing:

  • Hydraulic cylinder tubes
  • Transmission shafts
  • Camshafts
  • Toothed racks
  • Crankshafts
  • and much more ...



Thanks to our integration into the PÜTZ GROUP and the resulting synergy effects we are able to offer you not just machines and equipment but also the appropriate testing technology.


+49 7961 56499 0